Ok, I have looked all over the internet. Seen many things that I can never unsee in my quest to find out what the spline is on a toyota driveshaft. I know the spline count but I can't find any information on the involute or pressure angle. We tried to spline a shaft with the 30* angle and that isn't fitting correctly so now I am on the hunt for the proper involute cutter to get this shaft built.
Does anyone know or know where to find this information about the shaft? Clearly I need to get my eyeballs recalibrated because I thought that the 30* would be close enough to work.
Does anyone know or know where to find this information about the shaft? Clearly I need to get my eyeballs recalibrated because I thought that the 30* would be close enough to work.