i got the axle out.. the knuckles out.. the lower ball joints is super loose.. and top one didnt look bad but i figured i might as well replace both..
so i try to ball joint tool from HF.. nothing..it starts to budge but find out zerk fitting on top of the ball joint got smashed and it sunk inside the hole..
So whats the trick to taking these suckers off.. i pounded the crap out of it.. top and bottom.. Do people grind the tops off and drill them out or am i missing something.
Thanks
mark:shaking:
so i try to ball joint tool from HF.. nothing..it starts to budge but find out zerk fitting on top of the ball joint got smashed and it sunk inside the hole..
So whats the trick to taking these suckers off.. i pounded the crap out of it.. top and bottom.. Do people grind the tops off and drill them out or am i missing something.
Thanks
mark:shaking: